TV Antenna Installation & Repair in Collingwood, VIC 3066
Local antenna repairs and installs in Collingwood: we start with a meter reading at your roof, agree a fixed price, and retune every TV when we finish.
Rated 5.0 on GoogleThanks — we'll call you shortly.
Within 30 minutes during opening hours. Need it faster? Call 0497 098 109.
The Collingwood reception problem: reflections, not distance
Height helps less than you'd expect in Collingwood. Above a certain point a taller mast just sees more reflections. What matters is a position with a clean view toward east and a solid building behind the antenna rather than beside it, so we test several spots before fixing anything.
Collingwood signal facts
- Main transmitter
- Mt Dandenong
- Distance & direction
- 32 km, bearing 97° (east)
- Band & polarisation
- VHF, horizontal
- Channels
- VHF 6, 7, 8, 11 and 12 (plus UHF 32 for C31)
- Local repeater in reach
- Melbourne inner-city repeater (Bourke Place): 3.2 km at 239° (west-south-west), UHF vertical, 270 W
- What we usually fit
- A mid-gain VHF/UHF combination antenna on a short mast above the roofline — or, where the CBD repeater meters cleaner, a UHF antenna mounted vertically and aimed at it
Distances and bearings are calculated from the centre of Collingwood; your roof may differ by a few degrees. Repeaters are low-power and directional, so we always confirm with a meter on site.
The signal's route to Collingwood
Draw a line from Collingwood toward Mt Dandenong at 97° and it crosses Kew, Mont Albert, Box Hill North, Nunawading, Heathmont and Kilsyth South before reaching the transmitter 32 km away.
The shorter path to the CBD repeater (3.2 km at 239°) runs over Fitzroy, Carlton and Melbourne.
Practical tip: stand where your antenna is and face east. If you can see a big tree, a new two-storey house or a hill within a few hundred metres, that is the first suspect.
If you live in a block in Collingwood
Owners corporations in Collingwood usually want a written report before approving work. We provide meter readings for the head-end and the affected outlets, photos of the faulty component and a fixed-price quote.
Common Collingwood call-outs
- Multipath reflections from nearby towers causing blocky pictures on one or two channels
- Failed MATV amplifier or power supply taking out a whole building
- Corroded tap-offs and wall plates in older risers
How Collingwood compares with its neighbours
- Fitzroy — 0.7 km to the west-north-west, 0.6 km further from Mt Dandenong.
- Abbotsford — 1.0 km to the east, 1.0 km closer to Mt Dandenong.
- Carlton — 1.6 km to the west, 1.6 km further from Mt Dandenong.
- East Melbourne — 1.8 km to the south-south-west, 0.4 km further from Mt Dandenong.
Postcode 3066 also covers Collingwood North.
Collingwood prices, upfront
Every Collingwood job is priced before it starts. Repairs from $98; call-out waived when you go ahead; $120 saved on any new antenna install; discounts for pensioners, seniors and DVA card holders.
Collingwood: quick answers
Which way should a Collingwood antenna point?
Most antennas here point to Mt Dandenong, about 97° (east) and 32 km away, horizontally polarised on VHF. The CBD repeater is 3.2 km away on UHF with vertical polarisation, and in reflection-heavy streets it sometimes gives a cleaner lock — we meter both.
Why is my Collingwood signal strong but the picture still breaks up?
Strength is not quality. Reflections and electrical noise can give a high level with too many errors to decode. We measure the error rate as well as the level, and fix the cause rather than adding gain.
Can an amplifier make things worse?
Yes. In strong-signal areas an amplifier can overload, which causes exactly the pixelation people install it to cure. We often remove unnecessary amplifiers in inner suburbs.